Anchor bigfoot Manuale d'uso - Pagina 10

Sfoglia online o scarica il pdf Manuale d'uso per Impianto stereo Anchor bigfoot. Anchor bigfoot 13. Line array sound system
Anche per Anchor bigfoot: Manuale di avvio rapido (2 pagine), Manuale di avvio rapido (2 pagine), Manuale di avvio rapido (2 pagine)

Stampa la pagina
Anchor bigfoot Manuale d'uso
Bigfoot® Sound System Owners Manual
BATTERY REPLACEMENT
The batteries must be replaced every 2 – 3 years depending on usage
over time. Call Anchor Audio at 800.262.4671 to order batteries or
order them online at anchoraudioparts.com.
To replace your batteries you will need a Phillips screwdriver and to
follow these procedures:
NOTE: Proper operation of this product requires three (3) 12V batteries
connected in series.
1. Be sure the POWER is in the OFF
2. Remove wingnut from battery retainer bolt.
3. Swing battery retainer bracket away from terminals to free
the nearest battery.
CAUTION: DO NOT ALLOW BRACKET TO CONTACT
BATTERY TERMINALS
4. Disconnect wires from positive (red) and negative
(black) terminals.
5. Lift battery from tray and pull battery through opening to
remove.
6. For remaining two batteries, pull each forward in tray and
repeat steps 3-4, taking note of which wire connects to each
battery terminal.
7. Install new batteries one-at-a-time (reverse sequence from
removal) and slide each under the retainer bracket. Take care
to connect the proper wires to each battery terminal.
8. Reposition retainer bracket onto retainer bolt and fit wingnut
onto bolt to firmly secure bracket into place.
SYSTEM STORAGE & BATTERIES
Fully charge batteries before storage. For extended periods of
storage, charge the system at least once each month for a minimum
of 24 hours.
For System Setup & Operation Videos Visit Our Website: www.anchoraudio.com
BUILT-IN BATTERY MAINTENANCE
To preserve battery life, the built-in batteries MUST be FULLY
charged before the first use. Regardless of length of operation,
it is recommended that batteries be fully charged as soon as
possible after each use.
AC OPERATION & BATTERY CHARGING
Bigfoot Sound Systems include an automatic charging system
designed to properly charge and maintain the system's built-in
batteries. To charge batteries, plug the system into an AC outlet.
The BATTERY LEVEL INDICATOR will light when charging. The
CHARGE STATUS led will light bright red which indicates charge
process has begun and green indicates full battery. It takes
approximately 8 hours to charge the completely drained Bigfoot
batteries.
BATTERY SERVICE TIME
Fully charged batteries will yield approximately 6 – 8 hours of
continuous music at medium volume level (2 – 4 hours at full
volume or longer for speech only) . However, service times vary
depending on control settings and use of accessories.
BATTERY COMPARTMENT
NOTE: System Can Be Used During Charging!
Waste electrical and electronic products must
not be disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or Retailer for recycling advice.
MADE IN USA
SIX YEAR WARRANTY
10