ANDERBERG KLIMA HP50 Manuale di istruzioni - Pagina 6
Sfoglia online o scarica il pdf Manuale di istruzioni per Deumidificatore ANDERBERG KLIMA HP50. ANDERBERG KLIMA HP50 12.
Stampa la pagina9. Radio operation
The dehumidifier is available with or without a radio
sensor.
An error in radio reception (no reception for 10
minutes) will be signaled in the display by the error
code „05". This code „05" is also being displayed after
every activation of the device until it receives a valid
radio signal.
ATTENTION !
Never try to repair the device in case of
malfunction!
Otherwise you will forfeit your warranty claim and
risk damage to persons and the device.
Never intervene into the refrigerant circuit. This
must only be done by qualified personnel.
This device contains the cooling agent R-407C.
It must not be allowed to escape into the
atmosphere.
10. Overheating protection
If the compressor heats up to more than 80°C during
operation it is being shut off and only re-engaged
once it has cooled down to 50°C.
11. Keylock
To prevent accidental input and to protect the device
from unauthorized access it is equipped with a
keylock.
To activate this keylock hold down the buttons „+ %
RH" and „- % RH" simultaneously for about 5 seconds
until an acoustic confirmation. During activation the
display shows „88". To release the lock repeat this
process.
When a key is being pressed while the keylock is
active the display again shows „88".
12. Operating hours counter
The DEHUMID HP 50 is fitted with an operating hours
counter.
It is located on the back of the humidifier, above the
water tanks.
It measures the time in hours during which the device
is in operation.
13. Emptying the water tanks
Once the water tanks are filled to their maximum the
device will stop to operate and on the control panel
the LED „FULL" lights up.
In addition an acoustic warning signal will sound (3
times for 1 second). This will be repeated every 5
minutes for a total of 60 minutes, when the acoustic
warning will be shut off.
To put the device back into operation you have to
perform the following steps:
-
Remove the water tanks from the device. (The
water tanks are located on the back of the
device.)
-
Empty the water tanks completely.
-
Replace the water tanks back into the device.
Now the LED „FULL" will go out and after a short
period of time the device will resume operation.
14. Operation with direct drain hose
You can operate the DEHUMID HP 50 without the
water tanks, using a direct drain hose.
To activate the drain mode follow these steps:
- Remove the water tanks (on the backside)
- Turn off the device
- Unplug the mains
- Hold down the button „fan speed selector"
while plugging the mains back in.
The magnetic switches are now deactivated, which is
indicated by the flashing LED „FULL".
The device is now in direct drain mode and you can
operate it with the drain hose.
As soon as the water tanks are being re-inserted, the
drain mode is automatically being deactivated for
safety reasons.
ATTENTION !
Make sure that the dehumidifier cannot be
operated without a drain hose, once the magnetic
switches have been deactivated, damage may occur.