ATI Technologies RCV Manuale - Pagina 4

Sfoglia online o scarica il pdf Manuale per Apparecchiature industriali ATI Technologies RCV. ATI Technologies RCV 6. Vane motor rebuild

Manual, RCV Vane Motor Rebuild

Document #9610-50-1033-02

Assembly

Fig. 19 Place bearing on an arbor

press being sure to support the inner

race, insert threaded end of the

spindle and press in until it stops.

Fig. 22 Hold rotor in vise tightly

and lay Belleville washers on top of

bearing taking note of the orientation

(See diagram) Lay spacer on top of

them and install snap ring on top

of the spacer. Tighten spindle onto

rotor by turning collet body with a ½"

wrench clockwise.

Fig. 24 Stand tool motor side up and

install vanes.

Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 • Tel: 919.772.0115 • Fax: 919.772.8259 •

Use soft jaws for vise (Brass, Plastic,and Aluminum)

Fig. 20 Install bearing into front plate

and place on press bearing side

down being sure to support the inner

race of bearing. Insert threaded end

of the rotor and press in until it stops.

Front end plate should spin freely.

Fig. 23 Slide spindle into spindle

housing and install snap ring into

groove (may be easiest with 90* snap

ring pliers) Then slide all the way

forward.

Fig. 25 Install cylinder.

Fig. 21 Hold spindle in vise tightly and

tighten collet body onto spindle using

½" wrench and turning clockwise.

Fig. 24 Slide spindle into spindle

housing and install snap ring into

groove (may be easiest with 90* snap

ring pliers) Then slide all the way

forward.

Fig. 25 Give a drop of oil to each

vane.