Andesfit Health ADF-B27 Manuale d'uso - Pagina 13

Sfoglia online o scarica il pdf Manuale d'uso per Misuratore di glicemia Andesfit Health ADF-B27. Andesfit Health ADF-B27 18.

Stampa la pagina

CONTROL SOLUTION TEST

Material needed:

● Glucose Meter

● Test strips

● TaiDoc control solution

When to do a control solution test:

◆ When you suspect that the meter or test strips are not

working properly.

◆ If your blood glucose test results are not consistent with

how you feel.

◆ After the test strips are exposed to extreme conditions.

◆ After dropping the meter.

The control solution is to check that the meter and the test

strips can work together as a system and work correctly.

Step 1

Insert the test strip to turn on the meter. Insert the test strip into

the meter. Wait for the meter to display the drop symbol.

Step 2

You may press "S " button to select CTL mode, for

selecting the CTL mode, please refer to the "THE

TWO MEASURING MODES" section.

Step 3

Apply the control solution

Shake the control solution vial thoroughly before use.

Squeeze out a drop and wipe it off, then squeeze another drop

and place it on the tip of the vial cap.

Hold the meter to move the absorbent hole of test strip so it

touches the drop. Once the confirmation window fills completely,

the meter will begin counting down.

To avoid contaminating the control solution, do not directly

apply control solution onto a strip.

The result of the control solutions test appears on the display.

The result will not be stored under CTL mode.

The result of the control solutions test should be within the range

printed on the test strip vial label. If the test results falls outside

the specified range printed on test strip vial label, repeat the test.

Results falling outside the specified range may be caused by:

■ Error in performing the test

■ Expired or contaminated Control Solution

■ Expired or contaminated Test Strip

■ Malfunction of your Meter

If you continue to get control solution test results that fall outside

of the range printed on the vial, the system may not be working

properly, Do not use the meter. Please contact your distributor

support immediately

NOTE:Do not use the expired control solution.Only use the

TaiDoc control solution, you can purchase this product

through visits the website: www.taidoc.com

1.Start with the meter off, press the "M" button to turn on the

meter.The "

" symbol will flash with the time and date dis-

played on the

screen.