Electrolux 42 Manuale d'uso e istruzioni per l'installazione - Pagina 17
Sfoglia online o scarica il pdf Manuale d'uso e istruzioni per l'installazione per Cappa di ventilazione Electrolux 42. Electrolux 42 45. 30” and 36” free-standing range hood
Anche per Electrolux 42: Manuale di installazione, uso e cura (22 pagine)
Stampa la pagina
THE INSTALLATION SPACE
*Finished Width
Electrical
84 1/2" max
Area
83 1/2" min
Finished
Opening
24"
5"
Water Supply
3 1/2"
*The finished cutout width must be:
41-1/2" for 42" models
Water and Electrical Locations
The opening must be prepared with the
electrical and water supply located as shown.
The cutout depth must be 24"
The refrigerator will project forward, slightly
beyond adjacent cabinets, depending on
your installation.
Additional Specifications
• A 120 volt, 60Hz, 15 or 20 amp power
supply is required. An individual properly
grounded branch circuit or circuit breaker
is recommended. Install a properly
grounded 3-prong electrical receptacle
recessed into the back wall. Electrical must
be located on rear wall as shown.
Note: GFI (ground fault interrupter) is not
recommended.
• Water line can enter the opening through
the floor or rear wall. The water line
installed should be 1/4" O.D. copper tubing
between the cold water line and water
connection location. The line should be
long enough to extend to the front of the
refrigerator. Installation of an easily
accessible shutoff valve in the water line is
required.
Installation Instructions
3"
7"
7"
74"
From Floor
to Bottom
of Electrical
5"
3 1/2"
17
DIMENSIONS AND CLEARANCES
25-3/8" Case Depth
41"
Case Width
*81-3/4"
at Rear
42" Frame-to-Frame
Depth Including
Handles 26-7/8"
Product Clearances
These refrigerators are equipped with a 2
position door stop. The factory set 130° door
swing can be adjusted to 90° if clearance to
adjacent cabinets or walls is restricted.
130° Door Swing
B
A
Models
A
42"
12-3/16"
16"
Allow minimum clearances for Freezer
door (Dimension A) and Fresh Food door
(Dimension B) for a full 130° door swing
and to allow for drawer removal.
Four inch (4") minimum clearance is required
when door swing is adjusted to 90°. If the 90°
door stop position is used, drawer access is
maintained, but drawer removal is restricted.
See illustrations, pages 18 and 19, to
determine door swing interaction with
adjacent cabinets or countertops.
*Shipping height
The front height
may be adjusted
from 83-1/2" to 84-1/2"
by adjusting front and
rear leveling legs a
maximum of 1".
*84" From
Floor to
Top Frame
90° Door Swing
23-7/8"
Behind
Frame
C
D
D
B
C
D
24"
4"