- ページ 17

換気フード Electrolux 42のPDF 取扱説明書と取付説明書をオンラインで閲覧またはダウンロードできます。Electrolux 42 45 ページ。 30” and 36” free-standing range hood
Electrolux 42 にも：設置・使用・お手入れマニュアル (22 ページ)

ページを印刷する

THE INSTALLATION SPACE

*Finished Width

Electrical

84 1/2" max

Area

83 1/2" min

Finished

Opening

24"

Water Supply

3 1/2"

*The finished cutout width must be:

41-1/2" for 42" models

Water and Electrical Locations

The opening must be prepared with the

electrical and water supply located as shown.

The cutout depth must be 24"

The refrigerator will project forward, slightly

beyond adjacent cabinets, depending on

your installation.

Additional Specifications

• A 120 volt, 60Hz, 15 or 20 amp power

supply is required. An individual properly

grounded branch circuit or circuit breaker

is recommended. Install a properly

grounded 3-prong electrical receptacle

recessed into the back wall. Electrical must

be located on rear wall as shown.

Note: GFI (ground fault interrupter) is not

recommended.

• Water line can enter the opening through

the floor or rear wall. The water line

installed should be 1/4" O.D. copper tubing

between the cold water line and water

connection location. The line should be

long enough to extend to the front of the

refrigerator. Installation of an easily

accessible shutoff valve in the water line is

required.

Installation Instructions

74"

From Floor

to Bottom

of Electrical

3 1/2"

DIMENSIONS AND CLEARANCES

25-3/8" Case Depth

41"

Case Width

*81-3/4"

at Rear

42" Frame-to-Frame

Depth Including

Handles 26-7/8"

Product Clearances

These refrigerators are equipped with a 2

position door stop. The factory set 130° door

swing can be adjusted to 90° if clearance to

adjacent cabinets or walls is restricted.

130° Door Swing

Models

42"

12-3/16"

16"

Allow minimum clearances for Freezer

door (Dimension A) and Fresh Food door

(Dimension B) for a full 130° door swing

and to allow for drawer removal.

Four inch (4") minimum clearance is required

when door swing is adjusted to 90°. If the 90°

door stop position is used, drawer access is

maintained, but drawer removal is restricted.

See illustrations, pages 18 and 19, to

determine door swing interaction with

adjacent cabinets or countertops.

*Shipping height

The front height

may be adjusted

from 83-1/2" to 84-1/2"

by adjusting front and

rear leveling legs a

maximum of 1".

*84" From

Floor to

Top Frame

90° Door Swing

23-7/8"

Behind

Frame

24"