Atlas DPA-102PM Manuale d'uso - Pagina 6

Sfoglia online o scarica il pdf Manuale d'uso per Amplificatore Atlas DPA-102PM. Atlas DPA-102PM 20. Networkable 2-channel power amplifier with dsp

DPA-102PM - Networkable 2-Channel

Power Amplifier with DSP

Front Panel Description

Activation Switch

This switch turns the amplifier On or puts it into standby mode.

Power LED

The power will illuminate steady Blue when the power switch is pressed. This indicates the unit is active and will pass audio.

Channel 1 & 2 Clip LED

The Clip LEDs will illuminate Red if either channel of the DPA-102PM reaches maximum output power or if a fault is detected within

the amplifier. The DPA-102PM features an adjustable limiter circuit which helps prevent the amplifier from hard clipping. An occasional

flash of the LED is OK but if the LED illuminates continuously reduce the input level of the amp. If the Clip LED remains On after

reducing the input level, recheck the load connected to the amplifier.

Channel 1 & 2 Signal LED

The Signal LED illuminates Green if audio signal is present at the input of the amplifier.

Channel 1 & 2 Level Control

Channel 1 & 2 Level Control are enabled out of the box as the factory setting. Using the network GUI, the front panel controls can

be disabled allowing level control only through the network. If the front panel level controls are used, the knobs can be removed and

replaced with the included security covers to prevent tampering.

AtlasSound.com

1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.

Telephone: 800.876.3333 • Fax: 800.765.3435

– 6 –

Specifications are subject to change without notice.

Owner's Manual