ABSCO SHEDS 15151SK Manuale di montaggio e istruzioni - Pagina 13
Sfoglia online o scarica il pdf Manuale di montaggio e istruzioni per Deposito all'aperto ABSCO SHEDS 15151SK. ABSCO SHEDS 15151SK 20. N3/c1 frame kit
Anche per ABSCO SHEDS 15151SK: Manuale di montaggio (20 pagine)
Stampa la pagina
BRACING FOR BACK WALL
At the rear of the shed take the two frame
sections that are to be used for the back wall.
Connect them into a boxed configuration,
do not tek screw yet.
Place the unfastened boxed pieces against
the rear wall and slide them apart until they
make contact with both side walls.
It should look similar to what is shown on the
right, box them at this length.
Now secure to the rear wall with tek screws
from outside the shed at 148mm spacings.
BRACING FOR SIDE WALLS
Construction for the side wall, opposite to the door, is similar to the back wall.
1. Take the two frame pieces for the side wall, and partially box them together, do not tek screw yet.
2. Place the unscrewed box section against the previously installed wall bracing and slide the two
pieces apart until they make contact with it and the brace on the other wall. This is shown below.
Previously installed back wall bracing and new
side wall bracing on the right.
Absco Industries
Assembly Instruction Manual
N3/C1 FRAME KIT
FOR 1.5m WIDE TO
1.5m DEEP MODELS
C1220
C2950
Corner detail of back wall brace.
The other end of the same side wall brace
butting up against the previously installed front
Model: CYC15
C0660
C1220
wall brace.
02/03/2021
1.0
13