- ページ 13

屋外倉庫 ABSCO SHEDS 15151SKのPDF 組立・取扱説明書をオンラインで閲覧またはダウンロードできます。ABSCO SHEDS 15151SK 20 ページ。 N3/c1 frame kit
ABSCO SHEDS 15151SK にも：組立マニュアル (20 ページ)

BRACING FOR BACK WALL

At the rear of the shed take the two frame

sections that are to be used for the back wall.

Connect them into a boxed configuration,

do not tek screw yet.

Place the unfastened boxed pieces against

the rear wall and slide them apart until they

make contact with both side walls.

It should look similar to what is shown on the

right, box them at this length.

Now secure to the rear wall with tek screws

from outside the shed at 148mm spacings.

BRACING FOR SIDE WALLS

Construction for the side wall, opposite to the door, is similar to the back wall.

1. Take the two frame pieces for the side wall, and partially box them together, do not tek screw yet.

2. Place the unscrewed box section against the previously installed wall bracing and slide the two

pieces apart until they make contact with it and the brace on the other wall. This is shown below.

Previously installed back wall bracing and new

side wall bracing on the right.

Absco Industries

Assembly Instruction Manual

N3/C1 FRAME KIT

FOR 1.5m WIDE TO

1.5m DEEP MODELS

C1220

C2950

Corner detail of back wall brace.

The other end of the same side wall brace

butting up against the previously installed front

Model: CYC15

C0660

C1220

wall brace.

02/03/2021

1.0