Bose 201 Series IV Manuale d'uso - Pagina 6

Sfoglia online o scarica il pdf Manuale d'uso per Altoparlanti Bose 201 Series IV. Bose 201 Series IV 13. Direct/reflecting speakers
Anche per Bose 201 Series IV: Manuale d'uso (13 pagine), Manuale d'uso (12 pagine)

Stampa la pagina

Choose

the cord

Caution:

Never use broken or frayed wiring. It can result in electrical shock or damage.

It is important to use the proper gauge (thickness) of speaker wire. Standard zip cord

(2-conductor, 18-gauge wire) works best for most applications. You can find this wire at

most electrical and hardware stores.

You will need thicker wire if your speakers will be more than 30 feet (9 m) from a receiver or

amplifier. Refer to the wire recommendations

under "Technical information" on page 10, or

contact your authorized Bose_ dealer for more information.

Note: This wire may not be suitable for use inside finished walls. Check your local building

code requirements or contact an electrical installer for information.

Prepare

the cord

Speaker cord consists of two insulated wires. The insulation around one wire is marked

(striped, printed, or ribbed). This marked wire is always positive (+). The plain wire is always

negative (-). These wires correspond to the red (+) and black (-) terminals on the speakers

and the receiver or amplifier.

At the ends of each cord, strip approximately 1/2inch (12 mm) of insulation from both wires.

Twist the bare end of each wire, so loose strands will not touch across terminals. Be sure to

connect each wire to the proper terminal (positive to positive and negative to negative).

Note: It is sometimes difficult to distinguish wire markings. Inspect both wires carefully

Make

the connections

Caution:

Before making any connections, turn off your receiver or amplifier and unplug it

from the AC power (mains) outlet. Not doing so may result in damage to your system.

Just press the terminal tab on the back of each speaker to insert the appropriate wire

(Figure 4).

1. Connect one speaker cord to your right speaker.

a. Attach the marked wire to the red (+) terminal.

b. Attach the plain wire to the black (-) terminal.

2. Connect the other end of the same cord to the RIGHT SPEAKER OUTPUT of your

receiver.

a. Attach the marked wire to the red (+) terminal.

b. Attach the plain wire to the black (-) terminal.

3. Connect the second cord to the left speaker and

LEFT SPEAKER OUTPUT as described above.

Black terminal tab

Red terminal tab --

Marked wire

Figure

Terminal connections

October 30, 2001

AM183562_04_ V.pdf