Bose FreeSpace E-4 Manuale d'uso - Pagina 6

Sfoglia online o scarica il pdf Manuale d'uso per Convertitore multimediale Bose FreeSpace E-4. Bose FreeSpace E-4 15. Business music system
Anche per Bose FreeSpace E-4: Manuale d'uso (18 pagine), Manuale di avvio rapido (4 pagine), Manuale d'uso (14 pagine), Manuale d'uso (19 pagine)

Stampa la pagina

4.1 Introduction

This section provides instructions for installing the FreeSpace

E-4 system hardware on a tabletop or in a rack.

4.2 Included accessories

The following accessories are shipped with the E-4 unit in the

FreeSpace E-4 System Accessory Kit (PC030105).

• 2-terminal input connectors (6) – For wiring

Auto Volume mics to the

SENSE MICROPHONES jacks

• 3-terminal input connectors (2) – For wiring

equipment to the AUX MIC/LINE 3 jacks

• 4-terminal input connectors (3) – For wiring

equipment to the ZONE 4 LINE OUT,

PAGE/MIC/LINE 4, and

DIRECT IN/CONTROL jacks

• 2-terminal output connectors (5) – For wir-

ing speaker cables to the ZONE OUT jacks

• Rubber feet (4) – For installing the E-4 unit

on a level surface

• Replacement voltage label (2) – Used on

the OUTPUT VOLTAGE selection switch

• FreeSpace system Installer™

software CD – Contains application

software for programming the E-4

system

4.0 Hardware Installation

25 of 76

4.3 Placement guidelines

• Place the E-4 unit where it is protected from heat and allowed

adequate ventilation.

• Place the E-4 unit away from direct heat sources, such as heat-

ing vents and radiators.

• Make sure that air can circulate freely behind, beside, and

above the unit. Allow six inches on all sides.

Installer's Note: Do not allow the chassis to exceed the

maximum operating temperature of 50˚ C (122˚ F). Be aware

of conditions in an enclosed rack that may increase the tem-

perature above room-ambient conditions.

4.4 Shelf mounting the E-4 unit

The E-4 unit is ideal for shelf mounting. The included accessory

kit contains four rubber feet for the bottom of the E-4 chassis.

The rubber feet will protect the surface on which the E-4 unit is

installed and help prevent movement of the E-4 unit. Be sure to

follow the "Placement Guidelines" previously described when

choosing a location for the E-4 unit.