Ankom TDF Series Procedura di assistenza - Pagina 8

Sfoglia online o scarica il pdf Procedura di assistenza per Strumenti di misura Ankom TDF Series. Ankom TDF Series 9. Vacuum sensor installation
Anche per Ankom TDF Series: Procedura di assistenza (7 pagine), Procedura di assistenza (4 pagine)

Stampa la pagina

17.

Adjust the reported temperatures on the Touch Screen

Display with a calibrated thermometer accurate to at least

0.2˚C.

a. Obtain a calibrated thermometer and place it in the

immediate environment of the paddles.

b. Allow the temperature reading to equilibrate with the

environment.

c. Turn the TDF instrument on.

c-1. From the Select a Function screen, press Diagnostics

c-2. Service Mode

c-3. Temperature Sensor Corrections

c-4. Enter temperature offsets into the fields for each

station. For example, if the calibrated thermometer is

showing a temperature of 23.2˚C but the Uncorrected

temperature value for station 1 is showing a

temperature of 24.0˚C, enter an offset of -0.8˚C. If the

Uncorrected temperature value for station 2 is

showing a temperature of 23.0˚C, enter an offset of

0.2˚C. Whatever number is entered as the offset

(whether positive or negative) will be added to the

uncorrected value.

c-5. Write down the offset numbers you put in for each

Paddle Bar to later ensure they save to the instrument.

c-6. Select Save to Permanent Memory and exit out of

Diagnostics.

d. Turn the instrument off and then on again to check to

ensure the corrected value information saved properly.

e. Follow the above screen display selections again and check

to ensure the Temperature Sensor Corrections match those

that you wrote down after adjusting.

ANKOM Technology  2052 O'Neil Road  Email: [email protected] Phone: 315-986-8090  Fax: 315-986-8091

Paddle Bar Replacement

TDF

Service Procedure

Thermometer

TS021

Revised: 01/24/2017

pg. 8 of 9