ANLIDAR Mytorq MYBT-IM100 Manuale di funzionamento e manutenzione - Pagina 9

Sfoglia online o scarica il pdf Manuale di funzionamento e manutenzione per Cacciavite elettrico ANLIDAR Mytorq MYBT-IM100. ANLIDAR Mytorq MYBT-IM100 11. Cordless screwdriver

Stampa la pagina
1.
The best condition of using the tool is under 8 hours a day, do not over loaded.
2.
Do not attempt to repair or disassemble this cordless screwdriver without authorization. Always
have the device serviced by assigned factory or qualified person in order to have the warranty
effective continually.
3.
ANLIDAR is not responsible for any poor performance or damage caused by customers own
modification of the tool.
4.
It is necessary for the management to have individual operators read and follow up all
instructions in this manual. Do not attempt to repair or disassemble this cordless screwdriver
themselves.
5.
Removing protection cap by pry open the slots located on both side of the screwdriver as
indicated in the diagram 1 below. To install the protection cap, the cap gap facing downward and
push it into the slots. As indicated in the diagram 2 below.
Slots
Diagram 1
Diagram 2
6.
The torque measuring of
tension calibrator.
1.
SKC-LB1820B series of battery as options to fit in the device; you may consult with
ANLIDAR
local agent based on your task requirement.
2. The use of other than genuine
build-in protection system enforce no charging.
3.
charger with LED on is recommended.
MYCS-ID80-D
1.
Screwdriver stops along with three waring beep occurs while the motor speed is lower than 1000
rpm.
2.
PCB temperature detector preventing the screwdriver overheated; it stops along with three
waring beep occurs while the PCB temperature is over 70℃.
3.
Restarting the screwdriver which dismissing from a safety mood may come along with three
beep sounds.

Other Cautions

MYBT-IM100 i

Description of battery and charger

ANLIDAR
Waring beep sound
Insert
s completed by SKIDMORE-WILHELM model J bolt
batteries or screwdrivers can't be active due to the
8