Drytac HOT PRESS HGP260 Manuale d'uso - Pagina 9

Sfoglia online o scarica il pdf Manuale d'uso per Utensile elettrico Drytac HOT PRESS HGP260. Drytac HOT PRESS HGP260 19. Heated glass top vacuum press
Anche per Drytac HOT PRESS HGP260: Manuale dell'operatore (19 pagine)

Stampa la pagina

HOT PRESS USERS MANUAL

PERATING THE VACUUM PUMP

Automatic Control

For automatic control, the pump switch should be set in the AUTO

position. The Timer controls the length of the cycle in minutes and

seconds.

The Timer has three operating modes:

Set - Normal mode. The timer is ready to operate.

Pgm - Program mode. The preset time may be changed.

HAnd - Manual mode (see "Manual Operation" below).

When in Set mode, the timer displays the preset time.

When in Program mode, either the minutes or seconds digits will be

ﬂ ashing to indicate that you may change them as desired.

To Change The Preset Time

Enter the Program mode by pressing Button 1; either the minutes or

seconds digits will ﬂ ash. To alternate between minutes and seconds

press Button 2. Use Button 3 to increase or

Button 3

Button 3 to increase or

time. Once the desired value has been set, press Button 1 to return

to set mode.

To Start the Vacuum Cycle

In Set mode (when no digits are ﬂ ashing), press Button 3 to start the

cycle. The timer will indicate that the pump is on and begin to count

down. Once the preset time has elapsed, the pump will stop, the

vacuum will be released and the counter will return to showing the

preset time.

If you wish to stop the cycle part way through, simply press Button 4.

This will stop the pump, release the vacuum and reset the timer.

Manual Operation

Switching the PUMP switch to the MANUAL position will cause the

pump to start. The pump will run until the switch is returned to the

AUTO position.

The Timer also has a manual mode, which allows it to be used as

a simple On/Off switch. Press Button 2. While keeping Button 2

depressed, press Button 1. The timer will display the word hAnd.

Pressing Button 3 (start) will switch the pump on; pressing

Button 3

Button 3 (start) will switch the pump on; pressing

(stop) will switch it off. To return to automatic operation, press Buttons

2 and 1 as described above. Although this facility is available, we

recommend that you use the AUTO/MANUAL switch rather than the

hAnd function.

)

IMER

Button 4 to decrease the

Button 3 to start the

Button 3

Button 4

Timer Controls

Illustration 9A: Locations of controls for

vacuum cycle duration.