Drytac HOT PRESS HGP360 Manuale d'uso - Pagina 7

Sfoglia online o scarica il pdf Manuale d'uso per Utensile elettrico Drytac HOT PRESS HGP360. Drytac HOT PRESS HGP360 19. Heated glass top vacuum press
Anche per Drytac HOT PRESS HGP360: Manuale dell'operatore (19 pagine)

Stampa la pagina

HOT PRESS USERS MANUAL

MAIN CONTROLS

Initial Test

Verify that both of the circuit breakers on the rear panel of the press are

in the ON position (levers pointing to the right). Check that the Auto/

Manual

Manual switch located on the front panel is in the AUTO position, and

that the power switch is in the OFF position. Connect the power cord

to the electrical outlet. Remove any materials from inside the press,

then close and latch the lid. Turn the Pressure Adjustment Knob fully

clockwise (maximum vacuum).

Turn on the power switch on the front of the press. The displays on

the Timer and

Timer and

Timer

Temperature controllers should light up. The Timer will

normally indicate 2:00 and the temperature controller will indicate

room temperature. Within a minute or so, it will start to increase. After

about 15 minutes, the temperature should reach the setting that was

preset at the factory, normally 194°F (90°C).

Now press the Start button on the timer (the one in the upper right

corner). The vacuum pump should start, and the timer should begin to

count down. Within a few seconds, the pointer on the vacuum gauge

should start to move. Within 30 seconds, the reading should be steady

at 25" or higher.

When the timer reaches zero, the pump should automatically cut off,

and the vacuum should automatically be released. Check the vacuum

gauge, which should now be back at a zero reading.

Refer to the Troubleshooting section (pages 15-16) of this manual if

the equipment does not function as described above, or contact Drytac

for assistance.

ILLUSTRATION 7A: MAIN CONTROLS

PRESSURE ADJUSTMENT KNOB

Adjusts pressure for applications such as

mounting onto foam boards.

VACUUM PRESSURE GAUGE

Indicates actual vacuum pressure. A

normal reading is 25" or higher (with

the variable pressure adjustment set to

maximum).

AUTO / MANUAL SWITCH

Acts as a simple On/Off switch for the

pump if you do not need to use the Timer.

TIMER CONTROL

Controls the vacuum pump and pressure

release valve. At the end of the preset

cycle, the pump will turn off and the

vacuum will be automatically released.

POWER SWITCH

Switches on the heating system and the

timer.

TEMPERATURE CONTROLLER

Indicates the actual glass temperature

and maintains the temperature at your

chosen preset level.

Illustration 7B: Press Start button to

begin initial test.

Press Set Up