Daintree WWD2-4SM Manuale di installazione - Pagina 6

Sfoglia online o scarica il pdf Manuale di installazione per Sistemi di controllo Daintree WWD2-4SM. Daintree WWD2-4SM 7. Wireless controls wireless scene switch
Anche per Daintree WWD2-4SM: Manuale di installazione (7 pagine)

Stampa la pagina

Technical Data

Product Specifications
Dimensions
Weight
Power Supply
Battery Life
Operating Environment
Status Indicator
Mounting
Warranty
Purpose of Control
Construction of Control
Type 1 Action
Pollution Degree 2
Frequency band of radio operation:
Maximum radio transmit power:
Product Availablity
DESCRIPTIONA
Wireless Wall Switch, Surface Mount, 4 Button, Battery
Product Certifications and Regulatory Marks
Operating Control
E486320
The alkaline batteries supplied with your wireless switch are prone to leak over their lifetime, particularly when the battery
is mostly depleted. In the event that your battery leaks alkaline into the battery compartment, the chemicals can damage
the metal terminals.The chances of this happening can be reduced by changing the batteries in the switch promptly when
the batteries are nearing their end of their useful life. If a battery leak should occur, however, it should be cleaned up to
prevent damage to the wireless switch.
WARNING: THE CHEMICALS LEAKED FROM ALKALINE BATTERIES ARE CORROSIVE. WHEN HANDLING LEAKING BATTERIES,
PROPER PERSONAL SAFETY EQUIPMENT SHOULD BE USED, INCLUDING RUBBER GLOVES AND EYE PROTECTION.
If it is discovered that the batteries have leaked, wearing rubber gloves and using eye protection, remove all of the batteries
from the battery compartment and seal them in a plastic bag. The bag should be discarded in a manner in accordance with
local laws and regulations. Then, using a small cloth lightly moistened with vinegar or other mild acid, carefully wipe all of
the leaked battery chemicals from inside the battery compartment and allow it to dry. Once dry, the batteries may be
replaced and the switch may be reinstalled.
SIMPLIFIED EU DECLARATION OF CONFORMITY:
Hereby, Current Lighting Solutions, LLC declares that the radio equipment type WWD2-4SM is in compliance with Directive
2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address: www.gecurrent.com
114mm H x 70mm W x 15mm D
130g
(4) AAA1.5V battery
5yr(normal operation)
-10¡C to 40¡C (Indoor Use Only)
Network joined/Button triggered
Surface mount with either screw hole in backplate or with included 3M tape
5 years
Operating Control
Independently Mounted
2405-2480 MHz
8 dBm
FCC ID: 2AS3F-WWD4SM
IC : 25008-WWD4SM
currentlighting.com
© 2022 HLI Solutions, Inc. All rights reserved. Information and specifications subject to change
without notice. All values are design or typical values when measured under laboratory conditions.
LightOWL® Dual Technology Passive Infrared
and Acoustic Sensors (LODIA)
INSTALLATION INSTRUCTIONS
RTICLE NO
A
WWD2-4SM
WWD2-4SM
Installation Guide
Page 6 of 7
Rev 03/14/23
DT_WWD2-4SM_InstallSheet