Daintree WWD2-4SM Manuale di installazione - Pagina 7

Sfoglia online o scarica il pdf Manuale di installazione per Sistemi di controllo Daintree WWD2-4SM. Daintree WWD2-4SM 7. Wireless controls wireless scene switch
Anche per Daintree WWD2-4SM: Manuale di installazione (7 pagine)

Stampa la pagina

Supplier's Declaration of Conformity

47 CFR ¤ 2.1077 Compliance Information

Product Name: Wireless Wall Dimmer

Model No: WWD2-4SM

Supplier's Name: Current Lighting Solutions, LLC

Supplier's Website: http://www.gecurrent.com

Supplier's Address (USA): 25825 Science Park, STE 400, Beachwood, OH 44122

Supplier's Phone: 1-866-855-8629

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2)t his device must accept any interference received, including interference that may cause undesired operation.

This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic

Development CanadaÕs license-exempt RSS(s). Operation is subject to the following two conditions:

(1) This device may not cause interference.

(2) This device must accept any interference including interference that may cause undesired operation of the device.

L' é metteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d'Innovation, Sciences et

Développement économique Canada applicables aux appareils radio exempts de licence. L' e xploitation est autorisée aux

deux conditions suivantes:

(1) L'appareil ne doit pas produire de brouillage;

(2) L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d' e n compromettre le

fonctionnement.

FCC RF Radiation Exposure Statement: Specific Absorption Rate (SAR) is a measure of the rate of RF (radiofrequency)

energy absorption by the body from the source being measured. This equipment has been subject to the FCC RF Exposure

SAR Evaluation and this equipment complies with the FCC RF exposure limits set forth for the general population with

uncontrolled exposure. These requirements set a SAR limit of 1.6W/kg averaged over one gram of tissue.

Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged

to try to correct the interference by one or more of the following measures:

ÑReorient or relocate the receiving antenna.

ÑIncrease the separation between the equipment and receiver.

ÑConnect the equipment into an outlet on a circuit different from that to which the receiver is connected.

ÑConsult the dealer or an experienced radio/ TV technician for help

currentlighting.com

without notice. All values are design or typical values when measured under laboratory conditions.

LightOWL® Dual Technology Passive Infrared

and Acoustic Sensors (LODIA)

INSTALLATION INSTRUCTIONS

WWD2-4SM

Installation Guide

72-00187, Rev. D

Page 7 of 7

Rev 03/14/23

DT_WWD2-4SM_InstallSheet