DSC PC1150 Manuale di istruzioni - Pagina 6

Sfoglia online o scarica il pdf Manuale di istruzioni per Sensori di sicurezza DSC PC1150. DSC PC1150 13. Tyco security system instruction manual

Disarming the System

Enter the premises only through the door(s) designated by your installer as the Exit-Entry door. Entering

by any other door will sound an immediate alarm. As soon as the entry door is opened, the keypad

sounder will come on to indicate that the system should be disarmed. Go to the keypad and enter your

Access Code. If an error is made entering the code, press the [#] key and enter your code again. As

soon as the correct code is entered, the "Armed" light will go out and the keypad sounder will silence.

The correct Access Code must be entered before the entry time expires. The entry time delay may be

changed by your installer.

If an alarm occurred during the period the system was armed, the "System" light and the Zone Light of

the zone that caused the alarm will flash for two minutes. After the two minute period, the "System" light

and Zone Light will stop flashing and the system will return to the ready state. Pressing the [#] key during

the two minute period will cancel the alarm memory display.

If a trouble is present when the system is disarmed, the "System" light will come ON (See Viewing Trouble

Conditions section to determine the source of the trouble). Note that troubles will not display while the

system is in the Alarm Memory Display Mode.

If you return home and find that an alarm has occurred while you were away, it is possible that an intruder

may still be on the premises. Go to a neighbour's house, and call the local police to investigate.

Your Installer will inform you of whether or not that Quick-Arm feature is enabled on your system. When

the Quick-Arm feature is enabled, the system may be armed simply by pressing [ ][0] instead of a 4 digit

Access Code. This feature allows a person to arm but not disarm the system.

Press [#] to return to "Ready".

The door chime feature is used, while the system is disarmed, to provide a tone from the keypad each

time a door or window is opened or closed. The doors and windows which will provide this indication are

programmed by your installer.

Enter [ ][6][Master Code][6] to turn the door chime feature ON and OFF. When the command is entered,

the keypad buzzer will beep 3 times if the door chime feature is being enabled, and will sound one long

beep if it is being disabled.

Press [#] to return to "Ready".

Enter [ ][6][Master Code][8] for a 2-second test of the keypad lights, keypad buzzer, battery and the

siren.

Press [#] to return to "Ready".