DSC Classic PC1565 Manuale rapido - Pagina 13

Sfoglia online o scarica il pdf Manuale rapido per Pannello di controllo DSC Classic PC1565. DSC Classic PC1565 18. Security control panels

Stampa la pagina

Clearing Troubles

[4]

Failure to Communicate

Panel unable to send information to

central station. Check telephone

line, telephone number of Central

Station, format and reporting

codes. Dial number from handset

and listen for tones to ensure

number correct.

[5]

Zone Fault

The trouble will be indicated if any

zone on the system is in a trouble

condition, i.e. if it could not send

an alarm to the panel if required to

do so. Press [5] to view the zone

number.

[6]

Zone Tamper

This condition will only be gener-

ated for zones with DEOL resistor

supervision. This trouble is gener-

ated when a tamper is present.

Press [6] whilst in trouble mode to

view zone with a tamper condition.

[7]

Device Low Battery

Generated when a wireless device

exhibits a low battery. Press [7]

again to view which devices have

low battery.

[8]

Loss of System Time

This condition occurs when the

control unit is powered up and the

internal clock has not been set up.

[*][6][Master Code][1] to put in new

date and time.

Clearing Troubles

Power Up

Initial Start Up

Before turning on the mains power,

make sure that all electrical connec-

tions are completed and all devices

are connected correctly to the main

PCB. The two YELLOW leads on the

transformer should be securely

terminated in the two terminals

marked AC.

Before turning ON the mains power,

ensure you have the battery con-

nected to the control panel, then

insert the fuse into the terminal block

using the holder provided.

The control panel keypad will beep on

power up and the LCD version shows

the software version on the screen.

This is normal.

The Keybus voltage should read 12.0

volts to 13.8 volts in the normal state.

If a low Keybus error occurs, the

reading should be around 11.0 volts

to 11.5 volts. A critical condition on

the Keybus is anything between 10.0

volts and 10.3 volts. This will result in

a shutdown.

If you have a Keybus problem, you

should carry out the following: check

the connections on all Keybus-

connected devices; check the cable

run distance; check that cable type is

Initial Start Up

Features