Attero Tech Dante unDX2IO+ Manuale d'uso - Pagina 13

Sfoglia online o scarica il pdf Manuale d'uso per Accessories Attero Tech Dante unDX2IO+. Attero Tech Dante unDX2IO+ 16. 4 x 2 wallplate

3 – Device Configuration

Certain 3rd party manufacturers provide audio routing functionality from within their own configuration application.

Check the applications manual/help or contact the manufacturer in question to see if this is supported. If not supported

by a 3

party tool, the audio routing may be carried out using Audinate's Dante Controller. Dante Controller can be

obtained from the Audinate website (www.audiante.com/) and is available for both Mac and PC. Instructions on how to

use this application and about setting up routes on a Dante network can also be found on Audinate's website.

*Note: When using Dante controller, the unDX2IO+ will be shown using a default device name of "unDX2IO-######" where

'######' is the last six characters of the devices MAC address.

3.1 – IP Address Setup

********************************************************* IMPORTANT *****************************************************

Failure to correctly configure IP addresses will not allow an unDX2IO+ device to correctly authenticate in the unIFY Control

Panel software and while it will show up in Dante Controller, the devices parameters will not be available , the input and

output channels also won't be visible and routing of audio to and from the device will not be possible.

*****************************************************************************************************************************

In order to configure an unDX2IO+, both to set up internal parameters and also setup audio routing, the PC/Mac will need

to be able to communicate with the devices over the network. While all Dante devices will be discovered regardless of the

IP address setup on the PC or Mac, communication can only occur if the PC/Mac and the device have compatible IP

addresses.

By default, the unDX2IO+ is set to get a dynamic IP address. As with all Dante devices, if the unDX2IO+ does not find a

DHCP server to retrieve an IP address from, it will give itself an local link address sometimes also known as an automatic

private IP address (APIPA) instead. A local link IP address is always in the range 169.254.x.y.

To ensure communication, the PC/Mac can either be set to get a dynamic IP address, or be given a static IP address in the

range 169.254.x.y. The PC may require a restart if its IP address is changed for the change to take effect.

In some applications, IP addresses of devices may need to be set to something specific and that can be done once initial

communication has been established. Bear in mind however that if a static IP address is assigned to a device and that

static IP address is in a different range to the IP it was previously using to communicate with the PC/Mac, the PC/Mac will

lose communication with the device until such time as the PC/Mac IP address is also changed to an IP in range of the

devices new IP address.

Further information on IP setup for an audio system using Dante can be found in the FAQ's on the Audinate website

(https://www.audinate.com/resources/faqs).

 Attero Tech, LLC

1315 Directors Row, Suite 107, Ft Wayne, IN 46808

Phone 260-496-9668 • Fax 260-496-9879

www.atterotech.com

614-00036

unDX2IO+

User Manual