DT SWISS Ratchet LN Manuale tecnico - Pagina 15

Sfoglia online o scarica il pdf Manuale tecnico per Accessori per biciclette DT SWISS Ratchet LN. DT SWISS Ratchet LN 19.
Anche per DT SWISS Ratchet LN: Manuale tecnico (16 pagine)

Stampa la pagina
DT SWISS Ratchet LN Manuale tecnico

2.12 MOUNTING THE BALL BEARING AT THE NON DRIVE SIDE

1. Clamp the tool for the ring nut in the vise.
2. Push the hub shell with the drive side onto the tool
for the ring nut.
3. Push the axle with the long side first into the ball
bearing on the drive side.
4. Put on a new bearing on the non drive side with the
colored side facing outwards.
5. Put the installation cylinder onto the bearing.
6. Tap in the ball bearing carefully with slight hammer
strokes.
7. Check the ball bearings.
→ The hub must turn smoothly.
→ The hub must not have axial play.
8. If necessary, drive in the bearing on the non drive
side or loosen the bearing.
9. Repeat previous steps until the hub is turning
smoothly.
Ratchet LN - Technical Manual
15