DT SWISS Ratchet LN 기술 매뉴얼 - 페이지 15

{카테고리_이름} DT SWISS Ratchet LN에 대한 기술 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DT SWISS Ratchet LN 19 페이지.
DT SWISS Ratchet LN에 대해서도 마찬가지입니다: 기술 매뉴얼 (16 페이지)

페이지 인쇄
DT SWISS Ratchet LN 기술 매뉴얼

2.12 MOUNTING THE BALL BEARING AT THE NON DRIVE SIDE

1. Clamp the tool for the ring nut in the vise.
2. Push the hub shell with the drive side onto the tool
for the ring nut.
3. Push the axle with the long side first into the ball
bearing on the drive side.
4. Put on a new bearing on the non drive side with the
colored side facing outwards.
5. Put the installation cylinder onto the bearing.
6. Tap in the ball bearing carefully with slight hammer
strokes.
7. Check the ball bearings.
→ The hub must turn smoothly.
→ The hub must not have axial play.
8. If necessary, drive in the bearing on the non drive
side or loosen the bearing.
9. Repeat previous steps until the hub is turning
smoothly.
Ratchet LN - Technical Manual
15