ATX SignalOn Series Manuale di installazione e funzionamento - Pagina 13
Sfoglia online o scarica il pdf Manuale di installazione e funzionamento per Interruttore ATX SignalOn Series. ATX SignalOn Series 16. L-band splitter module
Anche per ATX SignalOn Series: Manuale di installazione e funzionamento (16 pagine)
Stampa la paginaINSTALLATION
4.
Installation
Each splitter module occupies a single slot in the chassis. Use the following procedure to install modules in the SignalOn
Series chassis.
1. Make sure the ATX logo (or any other front panel lettering) is readable. Slide the plug-in module into its designated
location in the chassis.
Warning: Never install equipment in a wet location or during a lightning storm.
2. Secure the module using its two captive retaining screws.
3. After each module is loaded into the chassis, refer to your work order, and connect the designated RF cables to the
appropriate BNC or F connectors on the modules in the chassis.
4. Carefully route cables through the cable management slots located on each side of the rear of the chassis. Use the
cable management guidelines found in this manual to route cable from the chassis to the rack/cabinet.
5. Perform any cabling or operational tests required at your facility.
SignalOn
Series – L-Band Splitter Module – Installation & Operation Manual
®
CHAPTER 4: INSTALLATION
4-1