ATX SignalOn Series Installatie- en bedieningshandleiding - Pagina 13
Blader online of download pdf Installatie- en bedieningshandleiding voor {categorie_naam} ATX SignalOn Series. ATX SignalOn Series 16 pagina's. L-band splitter module
Ook voor ATX SignalOn Series: Installatie- en bedieningshandleiding (16 pagina's)
Pagina afdrukkenINSTALLATION
4.
Installation
Each splitter module occupies a single slot in the chassis. Use the following procedure to install modules in the SignalOn
Series chassis.
1. Make sure the ATX logo (or any other front panel lettering) is readable. Slide the plug-in module into its designated
location in the chassis.
Warning: Never install equipment in a wet location or during a lightning storm.
2. Secure the module using its two captive retaining screws.
3. After each module is loaded into the chassis, refer to your work order, and connect the designated RF cables to the
appropriate BNC or F connectors on the modules in the chassis.
4. Carefully route cables through the cable management slots located on each side of the rear of the chassis. Use the
cable management guidelines found in this manual to route cable from the chassis to the rack/cabinet.
5. Perform any cabling or operational tests required at your facility.
SignalOn
Series – L-Band Splitter Module – Installation & Operation Manual
®
CHAPTER 4: INSTALLATION
4-1