Comtrend Corporation WAP-5940 Manuale di installazione rapida
Sfoglia online o scarica il pdf Manuale di installazione rapida per Punto di accesso wireless Comtrend Corporation WAP-5940. Comtrend Corporation WAP-5940 2. Wireless video bridge
Anche per Comtrend Corporation WAP-5940: Manuale di installazione rapida (2 pagine), Manuale di installazione rapida (2 pagine)
Stampa la pagina
Quick Install Guide
WAP-5940 | Wireless Video Bridge
A
Understanding the Wireless Video Bridge
AP/Client Switch
WPS Button
Reset Button
Gigabit
Ethernet Ports
On/Off Button
Power Jack
B
Initial Device Setup
NOTE: A minimum of two Wireless Video Bridges are required to create a proper connection.
AP Device Setup
1.
Setup the first Wireless Video Bridge by plugging in the power adapter and press the Power Button to the ON position (IN). Set the Wireless
Video Bridge to AP Mode by sliding the AP/Client Switch to the up position.
2.
Connect the Wireless Video Bridge to a Network Device (Gateway, Router, etc.) with an Ethernet (RJ-45) cable. You can use either Ethernet
ports of the Wireless Video Bridge to make this connection.
Client Device Setup
3.
Setup the additional Wireless Video Bridge closest to the location you want to directly connect the Internet Enabled Device (STB, DVR, etc.).
Plug in the power adapter and press the Power Button to the ON position (IN).
Set the Wireless Video Bridge to Client Mode by sliding the AP/Client Switch to the down position.
4.
Connect the Wireless Video Bridge to an Internet Enabled Device (STB, DVR, etc.) with an Ethernet (RJ-45) cable. You can use either Ethernet
ports of the Wireless Video Bridge to make this connection.
Client Mode When Lit
AP Mode When Lit
Displays WPS Connection Status
Displays WiFi Connection Status
Displays ETH 2 Connection Status
Displays ETH 1 Connection Status
Displays Power On/Off Status
Page 1