Comtrend Corporation WAP-5940 빠른 설치 매뉴얼

{카테고리_이름} Comtrend Corporation WAP-5940에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Comtrend Corporation WAP-5940 2 페이지. Wireless video bridge
Comtrend Corporation WAP-5940에 대해서도 마찬가지입니다: 빠른 설치 매뉴얼 (2 페이지), 빠른 설치 매뉴얼 (2 페이지)

페이지 인쇄
Comtrend Corporation WAP-5940 빠른 설치 매뉴얼

Quick Install Guide

WAP-5940 | Wireless Video Bridge
A
Understanding the Wireless Video Bridge
AP/Client Switch
WPS Button
Reset Button
Gigabit
Ethernet Ports
On/Off Button
Power Jack
B
Initial Device Setup
NOTE: A minimum of two Wireless Video Bridges are required to create a proper connection.
AP Device Setup
1.
Setup the first Wireless Video Bridge by plugging in the power adapter and press the Power Button to the ON position (IN). Set the Wireless
Video Bridge to AP Mode by sliding the AP/Client Switch to the up position.
2.
Connect the Wireless Video Bridge to a Network Device (Gateway, Router, etc.) with an Ethernet (RJ-45) cable. You can use either Ethernet
ports of the Wireless Video Bridge to make this connection.
Client Device Setup
3.
Setup the additional Wireless Video Bridge closest to the location you want to directly connect the Internet Enabled Device (STB, DVR, etc.).
Plug in the power adapter and press the Power Button to the ON position (IN).
Set the Wireless Video Bridge to Client Mode by sliding the AP/Client Switch to the down position.
4.
Connect the Wireless Video Bridge to an Internet Enabled Device (STB, DVR, etc.) with an Ethernet (RJ-45) cable. You can use either Ethernet
ports of the Wireless Video Bridge to make this connection.
Client Mode When Lit
AP Mode When Lit
Displays WPS Connection Status
Displays WiFi Connection Status
Displays ETH 2 Connection Status
Displays ETH 1 Connection Status
Displays Power On/Off Status
Page 1