Conairphone TAD2018 Manuale d'uso - Pagina 5

Sfoglia online o scarica il pdf Manuale d'uso per Segreteria telefonica Conairphone TAD2018. Conairphone TAD2018 17. Callkeeper digital answering system

Stampa la pagina

Installation

CAUTION

1. Never install telephone wiring during a lightning storm.

2. Never install telephone jacks in wet locations unless the jack is specifically

designed for wet locations.

3. Never touch uninsulated telephone wires or terminals unless the incoming

telephone line has been disconnected at the network interface.

4. Use caution when installing or modifying telephone lines.

Note:

Refer to "FCC Requirements" section before connection to telephone line.

To Install One 9 Volt Battery

One 9 volt battery (not included) is required

to maintain your personalized greeting and

recording messages during a power failure.

If there is a power failure and the battery is

not installed, both your personalized

greeting and recorded messages will be lost.

1. Make sure the AC Adaptor is unplugged

from the electrical outlet.

2. Use a pen or paper clip to loosen the

battery cover. Open the battery

compartment by pressing down on the

battery cover and sliding it away from the

unit. (Fig A)

3. Install one 9 volt battery.

4. Replace battery compartment door.

Note:

Install a replacement battery once a year to

insure proper operation of the power failure

protection feature.

The battery status is indicated by the

BATT. LOW indicator. If a fresh battery is

installed, the MESSAGE indicator stays lit

solid. If the battery is low/not installed, the

indicator will flash.

Choosing Your Location

Before making any connections, position

the TAD2018 near an AC power outlet

and a wall telephone jack (RJ11C).

Desk or Table Installation

1. If you are connecting your TAD2018 to

an extension telephone, plug one end of the

extension telephone line cord to the

extension line jack (located on back of

unit). Plug the other end into the

telephone.

2. Plug the telephone line cord (connected

to the back of the TAD2018) into the

Figure A

modular outlet in your telephone wall jack.

3. Connect the AC adaptor into the back of

the unit. Plug the other end into the AC

wall power outlet. Do not attach (staple,

etc.) the AC Adaptor cord to the building

wall (Fig. B).