ABTECH SAFETY SLIX 100 Manuale di istruzioni e manutenzione - Pagina 6

Sfoglia online o scarica il pdf Manuale di istruzioni e manutenzione per Prodotti per la cura della persona ABTECH SAFETY SLIX 100. ABTECH SAFETY SLIX 100 8. Stretcher
Anche per ABTECH SAFETY SLIX 100: Manuale di istruzioni e manutenzione (20 pagine)

ABTECH SAFETY SLIX 100 Manuale di istruzioni e manutenzione
Inspection and Cleaning of
The Slix 100 Stretcher
After each use the Slix 100 stretcher should be cleaned and inspected for damage by a competent person.
It is important that the stretcher and ancillary equipment is stored ready for use.
IF ANY CLOSURE OR STRETCHER STROPS HAVE BEEN IN CONTACT WITH ANY CHEMICAL,
SOLVENT, ALKALINE, ACID OR ANY CONTAMINANT WHICH MAY DEGRADE POLYETHYLENE,
POLYESTER OR NYLON THE STRETCHER AND/OR HAULING STROPS MUST NOT BE USED
UNDER ANY CIRCUMSTANCES.
IF THE STRETCHER HAS BEEN SUBJECT TO A DROP ONTO THE VERTICAL OR HORIZONTAL
HAULING POINTS DURING A PRACTICE OR A INCIDENT THE STRETCHER MUST BE INSPECTED,
BY A COMPETENT PERSON IMMEDIATELY AND BEFORE FURTHER USE.
Refer to Page 3-part identification.
Oil, grease, blood, body fluids or non aggressive contaminants may be removed with warm- not hot- water
and soap.
If a power washer is available, it may be used with care. After cleaning rinse thoroughly with clean water,
hang vertically and allow to dry in a warm, dry atmosphere.
DO NOT APPLY HEAT.
Inspect Hauling webbing Strops for physical or chemical damage. The integrity of the Hauling Strops is
essential and particular attention should be given to the stitching and the loop section of the Strops for
wear. If any damage is present DO NOT USE. Replace damaged Hauling Strops immediately.
Inspect all Closure Straps, Closure Buckles, Head & Foot Closure Straps, Carry Handles, Adjustable Foot
Loops and Buckles and Head & Side Grab Handles for physical or chemical damage. Damaged Straps
may be replaced. Contact the manufacture for replacements. DO NOT USE THE STRETCHER before
changing damaged Straps.
Inspect the Vertical Hauling Plate / Spinal Splint attachment point located at the head of the stretcher, for
damage and / or distortion. Inspect the area of stretcher around the Vertical Hauling Plate and the
Horizontal Attachment Points. If any distortion or splitting in the stretcher skin is found DO NOT USE.
IF IN ANY DOUBT ABOUT THE INTEGRITY OF THE SLlX100 STRETCHER PLEASE CONTACT THE
MANUFACTURER.
6