Anywhere WEBWHIP WIFI-1 Manuale d'uso - Pagina 12

Sfoglia online o scarica il pdf Manuale d'uso per Estensore Anywhere WEBWHIP WIFI-1. Anywhere WEBWHIP WIFI-1 16. Long-range wi-fi receiver

TROUBLESHOOTING

INTRODUCTION

6. In the "NETWORK" tab, make the following changes:

A. Network Role > Network Mode: Router

B. WAN Network Settings> NAT: Enable

C. LAN Network Settings> DHCP Server: Enable

D. LAN Network Settings> IP Address: 192.168.1.20

E. LAN Network Settings> Range Start: 192.168.1.30

7. Save the changes:

A. In the bottom right, press the "Change" button.

B. Select "Apply" to the question on the bar on top that says "Conﬁguration

contains changes. Apply these changes?"

8. Wait for about 25 seconds for device to make changes.

9. If the WebWhip was previously connected to a wireless router, follow steps 5-11 of

the Quick Install guide section of this manual to re-connect to it.

10. Follow the instructions in the "Initial Setup" section of this manual before

connecting to a Wi-Fi network.

Note: Do not forget to re-enable the Wi-Fi on your laptop if you disabled it.

B: Avoiding Interference:

If the device interferes with your radio or other electronic receivers, move the device

further away from those devices.

Warning: Unauthorized antennas, cables, and/or coupling devices are prohibited by

current FCC regulations. Please contact FCC for details: 1-888-CALL-FCC.

Changes or modiﬁcations in the product or settings, not expressly approved by

Shakespeare could void the user's authority to operate the equipment.

WIFI-1 / WebWhip

™

Wi-Fi Receiver Kit

Page 11