Anywhere WEBWHIP WIFI-1 User Manual - Page 12

Browse online or download pdf User Manual for Extender Anywhere WEBWHIP WIFI-1. Anywhere WEBWHIP WIFI-1 16 pages. Long-range wi-fi receiver

TROUBLESHOOTING
INTRODUCTION
6. In the "NETWORK" tab, make the following changes:
A. Network Role > Network Mode: Router
B. WAN Network Settings> NAT: Enable
C. LAN Network Settings> DHCP Server: Enable
D. LAN Network Settings> IP Address: 192.168.1.20
E. LAN Network Settings> Range Start: 192.168.1.30
7. Save the changes:
A. In the bottom right, press the "Change" button.
B. Select "Apply" to the question on the bar on top that says "Configuration
contains changes. Apply these changes?"
8. Wait for about 25 seconds for device to make changes.
9. If the WebWhip was previously connected to a wireless router, follow steps 5-11 of
the Quick Install guide section of this manual to re-connect to it.
10. Follow the instructions in the "Initial Setup" section of this manual before
connecting to a Wi-Fi network.
Note: Do not forget to re-enable the Wi-Fi on your laptop if you disabled it.
B: Avoiding Interference:
If the device interferes with your radio or other electronic receivers, move the device
further away from those devices.
Warning: Unauthorized antennas, cables, and/or coupling devices are prohibited by
current FCC regulations. Please contact FCC for details: 1-888-CALL-FCC.
Changes or modifications in the product or settings, not expressly approved by
Shakespeare could void the user's authority to operate the equipment.
WIFI-1 / WebWhip
Wi-Fi Receiver Kit
Page 11