Addictive audio F300.1 Manuale d'uso e installazione - Pagina 11

Sfoglia online o scarica il pdf Manuale d'uso e installazione per Amplificatore Addictive audio F300.1. Addictive audio F300.1 15. Fleck series amplifiers

Stampa la pagina

6. Re-attach the negative battery post from step 1.

7. Turn the head unit on and start at a low volume. Check amplifier to make

sure all wires are correct and no protection lights are on.

8. Set the head unit's tone controls, balance, and fader to the center or flat

position. Be sure to turn off any loudness or other signal processors.

9. Use a very clear original recording not mp3 or burned cd. Turn the volume

of the head unit to its maximum undistorted volume. On most quality head

units this is around 7/8 of the maximum volume.

10. Slowly turn up the gain (clockwise) to match the voltage output of the head

unit or until the speakers reach the maximum undistorted output.

11. Adjust the low pass, high pass, subsonic filters and phase to desired

settings.

12. Play a few different selections of music to check for overall system

balance.

13. ENJOY!

NOTE:

Many vehicles have small and insufficient wire to connect the alternator's positive

connection to the battery and to ground the battery to the vehicle chassis. To prevent

voltage drops, these wires should be upgraded to 4-0 AWG when installing one or more

Addictive Audio amplifiers.