Addictive audio F300.1 Manual del propietario y de instalación - Página 11
Navegue en línea o descargue pdf Manual del propietario y de instalación para Amplificador Addictive audio F300.1. Addictive audio F300.1 15 páginas. Fleck series amplifiers
Imprimir página6. Re-attach the negative battery post from step 1.
7. Turn the head unit on and start at a low volume. Check amplifier to make
sure all wires are correct and no protection lights are on.
8. Set the head unit's tone controls, balance, and fader to the center or flat
position. Be sure to turn off any loudness or other signal processors.
9. Use a very clear original recording not mp3 or burned cd. Turn the volume
of the head unit to its maximum undistorted volume. On most quality head
units this is around 7/8 of the maximum volume.
10. Slowly turn up the gain (clockwise) to match the voltage output of the head
unit or until the speakers reach the maximum undistorted output.
11. Adjust the low pass, high pass, subsonic filters and phase to desired
settings.
12. Play a few different selections of music to check for overall system
balance.
13. ENJOY!
NOTE:
Many vehicles have small and insufficient wire to connect the alternator's positive
connection to the battery and to ground the battery to the vehicle chassis. To prevent
voltage drops, these wires should be upgraded to 4-0 AWG when installing one or more
Addictive Audio amplifiers.
11