3P Technik DTC200 Manuale di installazione e funzionamento - Pagina 3

Sfoglia online o scarica il pdf Manuale di installazione e funzionamento per Controllore 3P Technik DTC200. 3P Technik DTC200 16.

Installation

Mains Voltage – There are exposed electrical conductors inside this appliance. This appliance must be

installed and serviced by a competent electricical technician to the current requirements of BS7671 and

IEEE recommendations. Before servicing this appliance, normal safe isolation procedures should be

implemented.

Do not touch the PCB while energised, it carries mains voltage.

Do not touch any connection terminals while energised.

Do not attempt to service this item when wet, or in a wet or high humidity environment.

If the housing of the control panel becomes damaged, you must shut down and securely isolate this

appliance immediately.

You must connect this appliance to a grounded 3 wire supply, protected by suitable overload protection.

Connected pumps and solenoids are earthed via the control panel, and may otherwise become live.

If the power cables are damaged, either to of from the controller then shut down and isolate this appliance.

The combined loading of pumps and solenoids connected to this appliance must not exceed 20A using the

supplied mains flex. Contact the manufacturer for advice if you need to exceed this rating.

Do not attempt to repair any part of the circuit board. Refer to the manufacturer for advice.

1 x Control Panel

4 x Level Sensors (magnetic reed switch mini-float)

1 x Wall mounting brackets

DTC200 is a wall mounted control panel designed to control 3 pumps or valves at 230VAC single phase, or

any voltage via external relays/contactors. No fluid passes through the control unit itself and it's location in

relation to other equipment is only constrained by cable distances.

The control panel cannot be mounted outside, it is splash proof but not designed to resist persistant rain or

immersion.

Connected pumps or valves mst be less than 10A@230VAC

Voltage drop will affect the cable size needed to take power to your pumps. Over very long runs, you may

find it more economical to install contactors near to the pumps, allowing you to control the pumps with a

DTC200 V1.20

Page 3

22/01/20