Danfoss TP7000M Istruzioni per l'installazione Istruzioni per l'utente - Pagina 9
Sfoglia online o scarica il pdf Istruzioni per l'installazione Istruzioni per l'utente per Termostato Danfoss TP7000M. Danfoss TP7000M 14. Electronic programmable room thermostat
Anche per Danfoss TP7000M: Manuale di istruzioni per l'installazione (9 pagine)
Stampa la pagina
- 1. Installation Instructions
- 2. Specification
- 3. Installation
- 4. DIL Switch Settings
- 5. Your Programmable Room Thermostat
- 6. Preset Programmes
- 7. Before You Start
- 8. Display Preferences
- 9. Setting the Clock & Day
- 10. Setting the OSC Period
- 11. Accepting the Preset Programmes
- 12. Before You Change the Preset Programmes
- 13. Programming in 7-Day Mode
- 14. To Convert to Thermostat Mode
- 15. To Programme Holiday Mode
- 16. User Overrides
The unit is now in RUN mode (colon
fl ashes in display) and the heating
will operate according to the preset
programmes.
Before you change the preset programmes
Your installer will have set your unit to operate in either 7-day
mode or 5/2 day mode. To tell which mode your unit is set
press PROG until Event 1 fl ashes in the display.
This unit is in 7-day mode and you can
programme different settings for each day of the
1
week (see page 9-10).
This unit is in 5/2 day mode and you can enter
one of set of programmes for weekdays and
another set for weekends (see page 10).
1 2 3 4 5
Programming in 7-day mode
(separate programmes for each day of the week)
a)
Press PROG until Event 1
fl ashes, then press DAY to move from
current day to Day 1.
b) Amend the time and temperature
as follows:
i)
Use + and – buttons to
alter time (press and hold to
change in 10 min increments).
Use L and M buttons to alter
ii)
temperature in 0.5°C (1°F) steps.
iii)
Press NEXT to advance to
next Event
iv)
Repeat steps i,ii & iii above for
Events 2, 3, 4, 5 & 6
1
9