Belden FX FUSION SC CONNECTOR Manuale di installazione - Pagina 4
Sfoglia online o scarica il pdf Manuale di installazione per Cavi e connettori Belden FX FUSION SC CONNECTOR. Belden FX FUSION SC CONNECTOR 8. 900μm tight buffer/250μm
Anche per Belden FX FUSION SC CONNECTOR: Manuale di installazione (8 pagine)
Stampa la pagina
4
Remove the ferrule stub assembly
from the clamshell by grabbing the
dust cap.
DON'T TOUCH
5.
Place the ferrule stub assembly
in the FX Fusion splice holder and
push it up to the position shown
below.
NOTE: It's recommended to remove the holder
from splicer
FX FUSION SC CONNECTOR
900µm TIGHT BUFFER/250µm - INSTALLATION GUIDE
the fiber.
PX106500-EN REV E
6.
Load the splice holder in the fusion
splicer.
7.
Load the rear housing, the spring
and the splice protection sleeve
on the 900µm tight buffer cable.
8.
Use the guide on the clamshell
and mark the tight buffer at
25mm.
Page 4 of 8