DAPAudio Powermix 1 Manuale - Pagina 13

Sfoglia online o scarica il pdf Manuale per Attrezzature per DJ DAPAudio Powermix 1. DAPAudio Powermix 1 18.

Occasional blinking of the LED is acceptable, since the amplifiers' limiters prevent distortion. Continuous

lighting indicates that degradation in the outputted sound is likely to happen. In that case, you should reduce

the master level.

27. PROTECT LED

The red Protect LED lights when one of the power amplifiers' extensive protection functions - against

thermal overload, HF-induction, DC at the outputs, and SOAR-protection - is activated. When the PowerMix

1 is in protect mode, the speaker outputs are muted and the inputs of the power amplifier are short-circuited

to prevent the amplifiers from being damaged. In this case you should first check if the frontal and/or rear

ventilation louvers are blocked. Another cause for the activation of the protect functions might be, that you

have connected more than two 8 Ohms speaker systems per power output. Please also disconnect the

SPEAKON connectors and check the speaker cables for short circuit. During the power-on operation,

the PROTECT LED always lights for about two seconds. This is normal. It indicates that the PowerMix's

protection circuitry is operational.

28. POWER LED

The blue Power LED lights when the PowerMix is turned on. If, after switching the PowerMix on, the LED

does not light, make sure that the mains plug is plugged in correctly. If the LED still doesn't light up, please

contact your DAP Audio dealer.

29 / 30 UP/DOWN FX1

The UP/DOWN-keys let you step through the effect programs one by one in increasing or declining order.

Keeping either one button pressed for a longer period of time allows scrolling the effect program numbers

with increased tempo.

31 / 32 UP/DOWN FX1

33. FX 1

You can change the FX value. The range is variable from 0 – 10.

34. AUX 1

You can change the AUX value. The range is variable from 0 – 10.

35 / 36. FX 1 On/Off

You can press the FX 1 button (35) to turn this section on. When the button is pressed the green LED (36)

lights up. It is recommended to

switch the FX-units off during announcements.

24 – 40 FX Section

24. Display FX1

You can change the FX 1 range by choosing one of the

16 available effects. You can alter the effect by pressing

the Up (29) or Down (30) buttons.

The display always indicates the actually selected

program number for the corresponding FX-unit.

25 Display FX2

You can change the FX 2 range by choosing one of the

16 available effects. You can alter the effect by pressing

the Up (31) or Down (32) buttons.

26. LIMIT LED

When the red Limit LED blinks, means the internal

power amplifiers are operated at their limits.