Apogee Symphony I/O Istruzioni e istruzioni - Pagina 5

Sfoglia online o scarica il pdf Istruzioni e istruzioni per Apparecchiature di registrazione Apogee Symphony I/O. Apogee Symphony I/O 9.

Symphony I/O Systems: 2 Units

NOTE: As of January 28, 2011, a maximum of 2 units is supported. Daisy chaining units

is not supported. The Secondary PC32 port on the back of the Symphony I/O is not yet

functional.

Pro Tools HD

✴ Software Release Beta 3.1 or later must be downloaded from ApogeeDigital.com

and installed. Following installation restart your computer.

✴ Power off Symphony I/Os

✴ Connect Loop Sync BNC cables to proper connectors in back of unit (Loop Sync Out

on Unit A to Loop Sync In on Unit B and vice versa). Make sure you don't

accidentally connect to the WC connectors!

✴ Connect 1st Symphony I/O to port of HD core card.

✴ Connect 2nd Symphony I/O to port of 2nd HD card.

✴ Power up units. Set both Symphony I/Os in "Pro Tools HD" Audio Interface Mode

(hold in the right encoders to check and change if needed)

✴ Launch Maestro 2 (Maestro 2 is Intel Mac only). Go to the "System Setup" tab and

check the checkbox "use Loop Sync" (in some versions of the software, the box is

ALWAYS checked and it's grayed out- this is normal). Also verify that unit A is the

"loop sync master" in the drop-down menu next to the checkbox.

✴ Wait for both units to lock. Unit A should be clocked to Internal displaying "INT" and

Unit B should display "LOOP".

The information in this document is confidential and proprietary. Redistribution without consent is strictly prohibited.