Apogee 10545 Manuale di istruzioni - Pagina 7

Sfoglia online o scarica il pdf Manuale di istruzioni per Giocattolo Apogee 10545. Apogee 10545 8. 1.9" ebay kit for aerotech rockets

Stampa la pagina

Make Ejection Canisters

*VERY IMPORTANT* MAKE SURE THE SWITCH IS IN THE

"EXTENDED/OFF POSITION" BECAUSE YOU WILL NOW BE

CONNECTING BLACK POWDER TO THE IGNITERS.

27. Take your latex glove and measure it at

about 1.25" from the end of the finger tips, then

cut 2 of the fingertips off.

28. Measure and cut a piece of string at

about 7" long. Cut it again in half. This will give

you two 3.5" pieces of string, one for each side.

29. Fill the inside of each cut finger tip from

the glove with 0.5 grams of black powder. *Your

rocket may need more or less black powder.

Consult your ejection charge calculator.

30. Set the Ebay down on a flat surface

and then place the Apogee/Drogue igniter

through the open end of the finger tip. Attempt

to squeeze most the air out of the bottom of the

fingertip.

31. Wrap the string around the cut finger tip

of the glove. Then tie a knot just above the

top of the black powder line being sure to

leave no air pockets above the powder.

32. For the Main igniter setup, repeat steps

30 & 31 above.

33. Tie the shock cord from the main body

tube of the rocket to the "E1/Apogee" side of the

sled. Use a knot that you can untie easily after

launch.

34. Tie your Kevlar cord to the "E2" end of

the Ebay sled. Now place the Ebay into your

upper parachute rocket tube (with the "E2" side

facing upwards towards the nose cone). Make

sure to align the switch hole and rivet holes.

The Kevlar cord passes through the tube and

ties to the nose cone.

35. Place the bottom end of your rivet into

the hole through your rocket and press it in.

Then place the top end of the rivet all the way

into the bottom piece. This will lock the Ebay

into place. Repeat this process for the remain-

ing two rivets. *To remove the rivet simply grab

the top piece and pull.

36. Take the main parachute bay tube and

slide your completed Ebay into the end.

37. Congratulations, the Ebay assembly

is complete and ready to be placed into your

rocket!

Igniter

For this

step rest

Ebay

on at

surface

1.25"

string

cut in half at 3.5"

glove ngertips

Steps 27-28

Igniter

For this

step rest

Ebay

on at

surface

Step 30

Step 33

Switch Hole

Step 29

Igniter

For this

step rest

Ebay

on at

surface

String

Step 31

Step 34

Inside the tube

Step 35

Page 7