Apogee 10545 Руководство по эксплуатации - Страница 7
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Игрушка Apogee 10545. Apogee 10545 8 страниц. 1.9" ebay kit for aerotech rockets
Make Ejection Canisters
*VERY IMPORTANT* MAKE SURE THE SWITCH IS IN THE
"EXTENDED/OFF POSITION" BECAUSE YOU WILL NOW BE
CONNECTING BLACK POWDER TO THE IGNITERS.
27. Take your latex glove and measure it at
about 1.25" from the end of the finger tips, then
cut 2 of the fingertips off.
28. Measure and cut a piece of string at
about 7" long. Cut it again in half. This will give
you two 3.5" pieces of string, one for each side.
29. Fill the inside of each cut finger tip from
the glove with 0.5 grams of black powder. *Your
rocket may need more or less black powder.
Consult your ejection charge calculator.
30. Set the Ebay down on a flat surface
and then place the Apogee/Drogue igniter
through the open end of the finger tip. Attempt
to squeeze most the air out of the bottom of the
fingertip.
31. Wrap the string around the cut finger tip
of the glove. Then tie a knot just above the
top of the black powder line being sure to
leave no air pockets above the powder.
32. For the Main igniter setup, repeat steps
30 & 31 above.
33. Tie the shock cord from the main body
tube of the rocket to the "E1/Apogee" side of the
sled. Use a knot that you can untie easily after
launch.
34. Tie your Kevlar cord to the "E2" end of
the Ebay sled. Now place the Ebay into your
upper parachute rocket tube (with the "E2" side
facing upwards towards the nose cone). Make
sure to align the switch hole and rivet holes.
The Kevlar cord passes through the tube and
ties to the nose cone.
35. Place the bottom end of your rivet into
the hole through your rocket and press it in.
Then place the top end of the rivet all the way
into the bottom piece. This will lock the Ebay
into place. Repeat this process for the remain-
ing two rivets. *To remove the rivet simply grab
the top piece and pull.
36. Take the main parachute bay tube and
slide your completed Ebay into the end.
37. Congratulations, the Ebay assembly
is complete and ready to be placed into your
rocket!
Igniter
For this
step rest
Ebay
on at
surface
1.25"
string
cut in half at 3.5"
glove ngertips
Steps 27-28
Igniter
Igniter
For this
For this
step rest
step rest
Ebay
Ebay
on at
on at
surface
surface
Step 30
Step 33
Switch Hole
Step 29
Igniter
For this
step rest
Ebay
on at
surface
String
Step 31
E2
E1
Step 34
Inside the tube
Step 35
Page 7