Duro Dyne SSFU Manuale d'uso - Pagina 5

Sfoglia online o scarica il pdf Manuale d'uso per Spruzzatore di vernice Duro Dyne SSFU. Duro Dyne SSFU 8. Adhesive applicator

Stampa la pagina

OPERATION

General Information:

1 - The typical assembly and installation shown on pages 4, 5 and 6 are only a guide for selecting and in-

stalling system components.

2 - Always use genuine Duro Dyne Super Sprayfast Universal parts and accessories, available from your

Duro Dyne Distributor. Refer to the Product Data Sheet for the pump. If you supply your own accessories,

be sure they are adequately sized and pressure rated for your system.

3 - Use a compatible, liquid thread sealant or Teflon tape on all male threads. Tighten all connections firmly

to avoid air or fluid leaks. Do not over-tighten plastic threads.

Pressure Relief Procedure:

WARNING

of an injury from accidental spray from the gun, splashing fluid or moving parts, follow the

Pressure Relief Procedure whenever you:

Are instructed to relieve the pressure,

Stop spraying,

Check or service any of the system equipment,

Or install or clean the spray tips.

Shut off the air to the pump.

Trigger the spray gun.

Open the Re-circulating Valve (see Figure-3) to relieve all fluid pressure, having a container ready to

catch the drainage.

Pump Shutdown:

WARNING

Flushing and Storage:

WARNING

Flush the Pump when necessary to prevent the fluid you are pumping from drying or freezing in the pump

and damaging it. Use a compatible solvent/mineral spirit.

Before storing the Pump, always relieve the pressure as noted at left and flush the Pump as follows:

(see Figure-2 below)

1 - Ensure the Re-Circulating Valve is in the "OFF" position.

2 - Open the Flush Fitting and secure the Flush Hose properly. Place the open end of the Flush Hose into a

container of water.

3 - Rotate Lever-A 90deg, then rotate Lever-B 90deg.

4 - Trigger the Spray Gun into another container until only clear water comes through.

5 - Store the Pump and Spray Gun properly until its next use.

Figure 2:

PRESSURIZED EQUIPMENT HAZARD

The system pressure must be manually relieved to prevent the

system from starting or spraying accidentally. To reduce the risk

To reduce the risk of serious injury whenever you are instructed to

relieve pressure, always follow the Pressure Relief Procedure.

To reduce the risk of serious injury whenever you are instructed to

relieve pressure, always follow the Pressure Relief Procedure.

TOP VIEW

Lever-A

Flush

Fitting

Re-Circulating

Valve

Pump

Lever-B

Flush Hose

Short Suction Tube

SIDE VIEW

Flush Hose