ADE PWI30 Manuale operativo - Pagina 7

Sfoglia online o scarica il pdf Manuale operativo per Bilance ADE PWI30. ADE PWI30 16. Electronic bench scales portion scale with induction charging

Stampa la pagina

Assembling and levelling the scale

Carefully remove the delivery contents from the packaging.

Put the load cross on the scale. Make sure that the holes in the centre of the load cross sit

over the pin in the centre of the housing. Attach the load cross to the quick-release fastener.

Place first the silicone mat and then the weighing plate on the load cross.

Place the scale on a level and stable installation surface and make sure that all four feet are

in contact with it. In addition, check the footing of the scale by means of the spirit level, the

bubble of which should be in the centre of a circle.

Put the weighing bowl on the scale. The four pins of the weighing bowl should grip into the

appropriate scale openings.

Insert the AC adapter into the socket located below the scale next to the power button. Connect

the AC adapter to an AC power outlet (pay attention to the correct voltage).

Using the scale

Switching on the scale

To turn on the scale, press and hold down the

button for about three seconds.

The display will show "ADE" for two seconds and will then automatically switch to weighing

mode. "0,000" is shown on the display.

If this is not the case, press the

button. As a result, measurement inaccuracies will be

compensated after turning on the scale and will be reset to zero before the actual weighing

process.

The display now shows "0.000" and the

figure indicates the zero position.

shows that

the weight value is stable. The scale is now ready for use.

If the display shows only "0.00", please check the selected digit interval in the parameter

settings of the unit of weight.

Determining weight

Make sure that the display shows "0.000",

and

as described above.

Put the object to be weighed on the weighing surface. The weight value will appear on the

display and

will show that the weight value is stable.

Zeroing the scale

If the weight is lower than 10% of the maximum capacity (here: 3 kg) and the display shows

the stability symbol

, press the

button to perform the zeroing function.

The display will show "0.000",

and

Tare function

If the weight value is greater than or equal to 10% of the maximum capacity (here: 3 kg) and

the display shows

, press the

button to perform the tare function.

The display will show "0.000",

and

PWI30-190920-Rev005-UM-en