4x4 TOUGH 21-50142U Manuale di istruzioni - Pagina 7

Sfoglia online o scarica il pdf Manuale di istruzioni per Automobile Accessories 4x4 TOUGH 21-50142U. 4x4 TOUGH 21-50142U 8. Roof racks

8. Slide each of the mounting brackets into the channel on the underside of the aluminium bar.

9. The oﬀ cuts of the underside rubber strip can then be cut to size and inserted into the channel

between the clamp and the end of the aluminium bar.

10. Secure the end caps onto the roof racks by tapping them over the aluminium channel end

with a soft hammer for a secure ﬁt.

11. Attach the roof racks to your vehicle's roof rails. When the mounting brackets are attached to

the roof rail, tighten the grip with the supplied Allen key on all 4 mounting brackets.

Allen key

12. Always ensure that the mounting bracket is correctly connected (A) to the roof rail. Incorrect

connection (B) can lead to unstable loads, causing a danger to other road users.

Open elevated rails

The end of the gripper MUST be

secured under the bar as shown in

image A. If the gripper is not

secured correctly as shown in image

B it may become dislodged.

13. When both roof racks are connected

correctly, secure them by ﬁtting the lockable

cover and lock with the security keys.

REMINDER:

Remove the keys once the roof racks have been secured and store them in a safe place.

DO NOT drive with the keys left in the lock.

14. The load must be evenly distributed over the area of the carrier system (B), and the centre of

gravity of the load kept as low as possible. Narrow and heavy loads (example: metal tubes) are to be

carried near the feet of the carrier system. Loads which overhang the ends of the carrier system (C)

and shall conform to any relevant laws or by-laws in force, and shall be adequately secured table

loads, causing a danger to other road users.

CAUTION: Do not use elastic straps to tie down load.

FOLLOW THE INSTALLATION STEPS TO INSTALL THE ROOF RACKS ONTO ANOTHER VEHICLE.

TRANSFERRING ROOF RACKS FROM ONE VEHICLE TO ANOTHER

FOR USE ON ROOF RAILS THAT HAVE A WIDTH OF NOT LESS THAN 15mm OR GREATER THAN 45mm

Using the Allen key provided loosen the adjustment screw on the mounting brackets to open the gripping

arms wide enough to remove the roof racks from the vehicles roof rails.

Allen key

Gripper Pivot

Adjustment Screw

Screw Pin