dymax BlueWave 50 Manuale operativo - Pagina 10

Sfoglia online o scarica il pdf Manuale operativo per Apparecchiature di illuminazione dymax BlueWave 50. dymax BlueWave 50 20. Uv light-curing spot lamp system

Stampa la pagina

1. Specifications

INSTALLATION AND SYSTEM INTERCONNECT

1. Connect the Power Cord to the Power Receptacle on the rear of the

unit and plug the Power Cord into a grounded wall outlet.

2. Connect the Footswitch to the Footswitch Connection (Figure 4) in

the rear of the unit.

3. Remove the protective cover from the BlueWave

Mount (Figure 5).

NOTE:

Always have a Lightguide or the protective cap engaged in

the Lightguide Mount. UV light can escape when the Shutter is

activated.

4. Remove the protective end caps from the Lightguide. Visually

inspect the two ends of the Lightguide to verify that no foreign

material is present. The ends of a DYMAX liquid-filled Lightguide can

be cleaned with isopropyl alcohol as required to remove foreign

material and deposition from outgassing.

5. Insert the large end of the Lightguide into the Lightguide Mount until

it snaps into place (Figure 6).

6. If desired, the Lightguide may be fastened into place by lightly

tightening the securing setscrew installed in the Lightguide Mount

(Figure 6). A hex wrench is provided with the BlueWave 50 for this

purpose. The setscrew should be tightened gently to prevent

damaging the Lightguide.

IMPORTANT!

To ensure that proper output of the system is

obtained, be sure to completely insert the Lightguide into the

Lightguide Mount prior to tightening the Setscrew. Be sure to lightly

tighten the Setscrew to ensure the Lightguide remains in place

during use.

NOTE:

Multi-leg Lightguides should be balanced by rotating the

Lightguide to obtain the desired UV intensity of each leg before

tightening the setscrew.

7. Turn the BlueWave 50's Power Switch on.

8. Allow the Bulb to warm up 4-5 minutes to obtain the maximum light

output.

CAUTION:

This is an arc, not a filament Bulb. Once ignited, it must

be left on for a minimum of 10 minutes to fully vaporize elements in

the Bulb. If not, the Bulb may be difficult to re-ignite. Each re-

ignition increases the rate of Bulb degradation.

NOTE:

The Bulb must cool before it can be re-ignited. Should the

Bulb extinguish, leave the Power Switch on. This operates the

Cooling Fan and allows the Bulb to re-light when it has cooled

sufficiently. If the Bulb fails to ignite, refer to the Troubleshooting

section of this manual. Bulb life is reduced approximately one hour

each time the Bulb is switched on and off. Avoid repeated cycles

that shorten Bulb life by leaving the unit on through breaks.

50's Lightguide

Footswitch

Connection

Power

Receptacle

Power Cord

Figure 4. Cable Connection,

BlueWave 50 Rear Panel

Figure 5. Lightguide Mount

Protective Cover Installed (left);

Protective Cover Removed (right)

Figure 6. Insert Lightguide into

Lightguide Mount

BlueWave

50 Light-Curing Spot Lamp