Hi-Force TWE Series Manuale di istruzioni per l'uso - Pagina 11
Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Utensile elettrico Hi-Force TWE Series. Hi-Force TWE Series 20. Electric torque wrench
Stampa la pagina
Prepared by:-
M.DAVIES
REV NO:-
1
ECO:-
3.1.8 Restart protection
With the gear and motor rotating, it is
not possible to engage the right/left
switch. This also applies for the on/off
switch. After the gear and motor have
stopped rotating for 2-3 seconds, the
machine can be restarted.
The respective direction LED will flash
blue.
3.2. TORQUE ANGLE MODE (OPTIONAL)
Push the button <Select> to switch
between the modes FAST u,
STRONG and angle of tilt mode M+α.
Releasing the button <Select> causes
the respective selection, including the
symbol, to flash three times. Then the
selected mode is engaged.
ATTENTION:
Angle of tilt mode selection is only
possible in gear 1 mode. If this
selection is attempted in gear 2 mode, a
warning signal sounds. The "2" in the
display and the two directional LEDs
will flash red alternately.
In angle of tilt mode, the last setting of
snugging torque alternates every 2
seconds (≡)...
...with the last setting for the continued
turning angle (°).
The setting visible at any time can be
changed by turning the potentiometer
wheel (2). Once the potentiometer
wheel stops, the set value flashes in the
display, as does the <Enter> button,
until the value is confirmed by pressing
<Enter>. Should the enter button not be
pressed within 3 seconds, the value is
not engaged and the original set value
will appear in the display.
OPERATING INSTRUCTIONS:
Electric Torque Wrench
Series: TWE
Approved by:-
Page 11 of 20
TDS:-
1399
Date: 25/03/14