Hi-Force TWE Series Gebruiksaanwijzing - Pagina 11

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Hi-Force TWE Series. Hi-Force TWE Series 20 pagina's. Electric torque wrench

Pagina afdrukken

Prepared by:-

M.DAVIES

REV NO:-

ECO:-

3.1.8 Restart protection

With the gear and motor rotating, it is

not possible to engage the right/left

switch. This also applies for the on/off

switch. After the gear and motor have

stopped rotating for 2-3 seconds, the

machine can be restarted.

The respective direction LED will flash

blue.

3.2. TORQUE ANGLE MODE (OPTIONAL)

Push the button <Select> to switch

between the modes FAST u,

STRONG and angle of tilt mode M+α.

Releasing the button <Select> causes

the respective selection, including the

symbol, to flash three times. Then the

selected mode is engaged.

ATTENTION:

Angle of tilt mode selection is only

possible in gear 1 mode. If this

selection is attempted in gear 2 mode, a

warning signal sounds. The "2" in the

display and the two directional LEDs

will flash red alternately.

In angle of tilt mode, the last setting of

snugging torque alternates every 2

seconds (≡)...

...with the last setting for the continued

turning angle (°).

The setting visible at any time can be

changed by turning the potentiometer

wheel (2). Once the potentiometer

wheel stops, the set value flashes in the

display, as does the <Enter> button,

until the value is confirmed by pressing

<Enter>. Should the enter button not be

pressed within 3 seconds, the value is

not engaged and the original set value

will appear in the display.

OPERATING INSTRUCTIONS:

Electric Torque Wrench

Series: TWE

Approved by:-

Page 11 of 20

TDS:-

1399

Date: 25/03/14