Hi-Force TWE Series Gebruiksaanwijzing - Pagina 12

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Hi-Force TWE Series. Hi-Force TWE Series 20 pagina's. Electric torque wrench

Pagina afdrukken

Prepared by:-

M.DAVIES

REV NO:-

ECO:-

3.2.1 Snugging torque settings

The snugging torque can be set between

positions 10 and 25. The snugging torque

settings are displayed by the icon ≡.

The setting approximately equates to the

percentage of the maximum output force of the

tool.

E.g.: Max. torque of the device 4,000Nm

Snugging torque

10≡ corresponds to ~10% = 400Nm

25≡ corresponds to ~25% = 1,000Nm

3.2.2 Setting the continued turning angle

The continued turning angle can be set from 0 to

max. 90°.

3.2.3 Starting the bolting process

Operate the on/off switch to start the bolting

process with the application of the snugging

torque.

Apply the torque at slow motor speed in order to

keep the dynamic forces low.

When the snugging torque is achieved, a signal

will sound, the direction LED will flash blue,

the display changes to rotating angle (°) and the

motor clearly increases in speed.

The display shows the current angle, counting

up. Shortly before the pre-selected angle is

reached, the device reduces speed and switches

off automatically.

3.2.4 Overload of the device in the Torque-Angle Mode

If the torque required for angle tightening is

outside of the device output, the process will be

interrupted and OLOAD will flash in the display

for 3 seconds.

Additionally, an acoustic warning signal sounds,

the two light diodes flash red alternately. The

message is documented.

OPERATING INSTRUCTIONS:

Electric Torque Wrench

Series: TWE

Approved by:-

Page 12 of 20

TDS:-

1399

Date: 25/03/14