Hi-Force TWE Series Інструкція з експлуатації Посібник з експлуатації - Сторінка 12
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Електроінструмент Hi-Force TWE Series. Hi-Force TWE Series 20 сторінок. Electric torque wrench
Друкувати сторінку
Prepared by:-
M.DAVIES
REV NO:-
1
ECO:-
3.2.1 Snugging torque settings
The snugging torque can be set between
positions 10 and 25. The snugging torque
settings are displayed by the icon ≡.
The setting approximately equates to the
percentage of the maximum output force of the
tool.
E.g.: Max. torque of the device 4,000Nm
Snugging torque
10≡ corresponds to ~10% = 400Nm
25≡ corresponds to ~25% = 1,000Nm
3.2.2 Setting the continued turning angle
The continued turning angle can be set from 0 to
max. 90°.
3.2.3 Starting the bolting process
Operate the on/off switch to start the bolting
process with the application of the snugging
torque.
Apply the torque at slow motor speed in order to
keep the dynamic forces low.
When the snugging torque is achieved, a signal
will sound, the direction LED will flash blue,
the display changes to rotating angle (°) and the
motor clearly increases in speed.
The display shows the current angle, counting
up. Shortly before the pre-selected angle is
reached, the device reduces speed and switches
off automatically.
3.2.4 Overload of the device in the Torque-Angle Mode
If the torque required for angle tightening is
outside of the device output, the process will be
interrupted and OLOAD will flash in the display
for 3 seconds.
Additionally, an acoustic warning signal sounds,
the two light diodes flash red alternately. The
message is documented.
OPERATING INSTRUCTIONS:
Electric Torque Wrench
Series: TWE
Approved by:-
Page 12 of 20
TDS:-
1399
Date: 25/03/14