Gaggenau ER 212 Istruzioni per l'installazione - Pagina 3

Sfoglia online o scarica il pdf Istruzioni per l'installazione per Forno Gaggenau ER 212. Gaggenau ER 212 5.

Fitting the built-in frame

Explanations of the drilling template on page 47

A – Left cabinet side

B – Right cabinet side

C – Cut off here if the cabinet wall is 22 mm thick

D – Cut off here if the cabinet wall is 19 mm thick

E – Cut off here if the cabinet wall is 16 mm thick

F – Face side of the cabinet wall

G– Outer cabinet wall

H – Centre of hole for base plate

Fig. 4

The ER 212 built-in frame can be combined

with the Gaggenau EM 119 microwave unit.

Other combinations are not permissible and

may damage the microwave unit or the built-in

cabinet.

Observe the assembly instructions. The ven-

tilation slot shown in the installation drawing

must be produced in the built-in cabinet.

The microwave unit may only be installed with

a permanently fitted intermediate shelf meas-

uring at least 16 mm (between oven and micro-

wave unit) and the intended base plate.

Proceed as follows:

– Secure the base plate on the intermediate shelf of

the built-in cabinet with the four included wood

screws (Fig. 4). To do this, use the template on

page 47.

– Screw the air baffle onto the upper side of the

recess in the appliance:

Distance from cabinet front to hole:

340 mm

Distance from left cabinet side to left hole:

80 mm

Note:

before connecting the appliance, make sure that

the voltage specified on the rating plate agrees

with your household installation voltage.

– Connect the microwave unit to the power mains

and place it on the base plate in the built-in

cabinet. To fit the front door, push the appliance

a little towards the rear in the built-in cabinet.