Great Lakes MINISTAR S Manuale operativo - Pagina 10

Sfoglia online o scarica il pdf Manuale operativo per Apparecchiature dentali Great Lakes MINISTAR S. Great Lakes MINISTAR S 13.
Anche per Great Lakes MINISTAR S: Suggerimenti per la risoluzione dei problemi e la fabbricazione (2 pagine)

Heating Cycle

There are two options to program the heating times:

B B

When constructing an orthodontic retainer, the pellets

placed against the occlusal-incisal margin cover the wax

holding the wires facially and act as an insulator when the

heated material is formed.

Improper packing of a model can cause a blowout, air leak,

or machine malfunction. It is important that there is no

sudden drop of the pellet margin at the inner cup wall, or

that the model is not positioned too high or low within the

cup. This allows the material to be overstretched, thinning

it to where a hole is created and air blows through.

In some instances, an air leak could cause inferior material

adaptation that can result in a poorly fitted appliance.

Mounted models should be splitcast. If the model cannot be

removed from the mounting, the pellet level will need to be

at a slight incline to appliance termination areas.

1.) Manual Entry:

•

Press the Power Switch (A) of the MiniSTAR S to activate

the machine.

•

Press the Time Button (B) to manually set the time. Using

the keypad, input the appropriate heating time (following

manufacturer's suggested heating time) for the material

to be thermal formed.

•

Press the Code portion of the Code/Scan Button (C) if you

wish to manually set both the heating and cooling times.

Note: During long heating cycles or continual use,

the lamp can become extremely hot.

- Caution is advised to prevent skin burns -