GREAT PLANES Electrifly Rifle Manuale di istruzioni - Pagina 9

Sfoglia online o scarica il pdf Manuale di istruzioni per Giocattolo GREAT PLANES Electrifly Rifle. GREAT PLANES Electrifly Rifle 16.

also used Shoe Goo to glue the ESC wire to the side of the

fuselage so it wouldn't get in the way of the battery or aileron

servo. Other, non-permanent adhesive such as RTV silicone

would also be suitable for this.

Mark the Balance Range

❏

1. Use a ﬁ ne-point, felt-tip pen to mark the forward, mid

(recommended) and aft C.G. locations on the bottom of both

sides of the wing 1/2" [13mm], 11/16" [17mm] and 7/8" [22mm]

back from the leading edges where they meet the fuselage.

❏

2. Cut the C.G. Marking Guide from the back of the

manual. Use the guide to draw lines across the marks you

made in the previous step.

❏

3. Lay strips of vinyl tape across the balance lines where

indicated by the arrows on the guide. These tape strips,

aligned with the sharpened supports on the balance stand,

will keep the plane from slipping off the stand.

Refer to this photo while hooking up the ailerons.

❏

1. Test fit the aileron servo in the plywood servo

mount on the bottom of the wing. If necessary, carefully

trim the mount to accommodate your servo, then mount

the servo with the included servo screws (or the screws

that came with your servo).

❏

2. Temporarily remove the servo, harden the screw

holes with a drop of thin CA, and allow to harden. Then,

remount the servo.

Aileron

Torque

Rod

❏

3. Mount a micro screw-lock connector to each torque

rod horn with the retainers. Thread the horns onto the

torque rods until the tops of the horns are 1/8" [3mm] down

past the ends of the rods.

Screw-lock Connector

Torque Rod Horn

1/8" [3mm]